How to remove PET tape residue without damaging surfaces

What is PET Tape?
Definition and Uses：PET tape which is short for Polyethylene Terephthalate tape is a highly strengthened, durable and transparent tape. It has been because of its exceptional adhesive properties that this tape is widely used for sealing bundling, labeling, and packaging.

Removing PET Tape Residue
Preparation：You need to prepare as many of these items as possible before you attempt to get rid of PET tape. Rubbing alcohol or isopropyl alcohol, Warm soapy water, Soft cloths or sponges, Plastic scraper or credit card, Cotton swabs, Mild adhesive remover (optional)

Step-by-Step Guide
Assess the Surface: First, determine the type of surface that has PET tape residue which needs cleaning. This factor is important since cleaning techniques depend on the type of material used to prevent any damage.

Softening the Adhesive: Pour a small amount of rubbing alcohol to a soft piece of cloth. Lightly dab the residue on the surface with the wet cloth to help in softening the adhesive. Do not rub the cloth on the surface as it may cause the residue to spread elsewhere on the surface or scrape the surface as well.

Gentle Scraping: After the adhesiveness has been relaxed, using a plastic scraper or an old credit card, gently scrape and lift off the residue in correct pulling motion. When scraping, place the scraper low to the pointed surface to avoid scratching.

Cleaning the Surface: After scouring the surface to dislodge most of the residue, the area will rest with some warm soapy water to clean any unearthed glue. Tenderly erase the surface using either a soft towel or sponge.

Final Touch-Up: When there are still remnants of a product that have dried up completely, take a cotton stick and soak it in rubbing alcohol and then apply it to the affected area. After the glue breaks down, remove it with a clean rag.

Rinse and Dry: After cleaning the soiled area, rinse it with clean water to dislodge any wash water substances that might be left on the surface of the wash. Using a clean towel, dry the clean area or permit it to remain uncovered until it is dry.

Alternative Methods
Gently Applying Adhesive Remover: If the above method does not full such as mostly do the removal, then try to apply a gentle type of adhesive such a remover that does not normally apply to common surfaces. It is always important to follow the communication of the manufacturer as well as perform a patch test on an actual site to determine if there will be surface damage.

Using Heat: This is so in all surfaces that have not been removed, in gentle heat application, adhesion may be released. Use a hairdryer on setting and blast the spot for some which would help melt the gunk. Be extra careful not to do it too much as it could lead to the melting of some materials.